Mode Ampoule Caméra de Sécurité 2MP - Surveillance Haute Définition et Sécurité Maximale !

1. Frequently Asked Questions Q: What is the application of the camera? A: This camera uses the Yi Lot app. You can download it in APP Store, it can be used on IOS and Android. 2. Quick guide to connect the smart camera 1. Use your mobile phone to scan the QR code on the user manual, or search "Yi Lot" APP in Google Play or App Store to install it on your mobile phone . And create your account step by step. 2. Make sure your wifi router is ready and remember your wifi router password. 3. Make sure you have connected your mobile to your wifi. Also open your location on your mobile phone. 4. Connect the camera to your outlet for power. 5. Wait about 30 seconds, the camera will rotate left to right and up and down. Then about 20 seconds later, the camera will say “set your camera by AP hotspot or scan code”. (Note: If the camera does not work in this step, please reset the camera. On the camera head, next to the SD card slot, you will see the reset hole. Use a pin to lightly press for 3 to 5 seconds , until the camera voice reset successfully.Release the rest button, then the camera will perform step 5). 6. In "YCC365 Plus" APP, tap "+" in the upper right corner. Select "dome camera", then select "Add device by scanning code". Click Next”. Fi then press "Next". 8. A QR code will appear on your phone screen. Place the QR code in front of the camera lens for the camera to read the QR code. You need to move slowly the QR code forward or backward at a distance of 10cm to 30cm from the camera lens 9. After the camera reads the QR code, it will play the sound "Say" and the voice "Please wait for the Wi-Fi to connect" and the voice "Please wait for it to connect to the Internet". Now press the "Beep or flash" button in the app. Then wait. 10. Finally, the camera will show "Internet connected, welcome to use cloud camera". And your app will also appear connected. Now you can use the camera on your phone. your cell phone. How to use SD card for memory 1. Please use C10 (Class10) or above SD card. I suggest buying with the camera. 2. Before use, please format your SD card. 3. Disconnect the power from the camera. Then insert the SD card into the card slot of the camera. 4. Reconnect the camera to electricity for power. 5. If your camera has already been added to the app, please wait about 30 seconds and then refresh the device list, the camera will connect to the internet again. If your camera hasn't been added to the app, just follow the "Quick guide to connect a smart camera" above to add it. 6. In the app, go to memory card setup/management, select "Alarm recording" or "Continuous recording" recording modes.